Cleaning program Jura S70

Hello and good morning,

I strongly suspect that any electronic component is defective.

After switching on the display shows rinse, then immediately clean with a beep.
Only the cleaning program can no longer be started. Also a reset did not bring any success.
I suspect that any electronic component is crossed over.

There are some components, from power electronics to over a triac ect.

Can the error somehow be narrowed down?

Other runs the Jura top.

Many thanks

Gruß

Harald

Reset? What are you talking about? What exactly are you doing to start the cleaning program? Does the display change if you do anything?

--------------------
Grüße, Manuel

Jura ENA Micro 9 (Küche)
Jura xF50 (Büro)
wechselnde Besetzung in der Werkstatt...
P.S.: Support gibt's im Forum, nicht per PN o.ä.

Flushing after switching on is normal...

Is the cleaning button perhaps only defective, so does not switch properly anymore?

How to reset the machine? I'm also very interested in that!

--------------------
Pessimist: Ganz schön dunkel hier...
Optimist: Ich seh ein Licht am Ende des Tunnels...
Realist: Mist, da kommt ein Zug...
Zugführer: Was machen die 3 Deppen auf den Gleisen?

--------------------
Grüße, Manuel

Jura ENA Micro 9 (Küche)
Jura xF50 (Büro)
wechselnde Besetzung in der Werkstatt...
P.S.: Support gibt's im Forum, nicht per PN o.ä.

It's probably a reset pin, but I haven't looked for it myself yet...
In fact "power out" is the same on devices that don't have a buffer battery. Then the processor will make a cold start anyway...

--------------------
Pessimist: Ganz schön dunkel hier...
Optimist: Ich seh ein Licht am Ende des Tunnels...
Realist: Mist, da kommt ein Zug...
Zugführer: Was machen die 3 Deppen auf den Gleisen?

Hello,

If the Jura is switched off, pressing 'N' and '+' simultaneously triggers a reset and acknowledges it with an 'OK' in the display.

Gruß

Harald

Cool!
Do you know if there's an internal reset?

--------------------
Pessimist: Ganz schön dunkel hier...
Optimist: Ich seh ein Licht am Ende des Tunnels...
Realist: Mist, da kommt ein Zug...
Zugführer: Was machen die 3 Deppen auf den Gleisen?

Hi Dancemann,

>this I found under

http://franziskus.org/2010/01/17/reset-ein...pressomaschine/

.

More is not written.

With our Jura S75 a reset is triggered by simultaneously pressing 'N' and '+' and acknowledged with an 'ok' in the display. The machine must be switched off for this purpose. After that all keys behind the door work again as usual and the machine could be cleaned.
Furthermore there seems to be the combination 'N' + 'Descale' as well as 'Filter' + 'Descale' for other machines.
Furthermore I found out that the combination 'big cup' + 'two big cups' shows something like the version of the Logiprint. With us 'E1300 MASK 4′.
For all key combinations the following applies: keep pressed for longer than two seconds when the machine is switched off.

--------------------
Grüße, Manuel

Jura ENA Micro 9 (Küche)
Jura xF50 (Büro)
wechselnde Besetzung in der Werkstatt...
P.S.: Support gibt's im Forum, nicht per PN o.ä.

Cool. I have to try it out on occasion :-)