AEG Caffe Silenzio - Machine spinning - Repair

Hello together,

the machine fills the brewing group with coffee grounds and the brewing head moves to the pump. When it arrives there, however, it is not water that is pressed through but the head moves to empty it, stops there and then says that the coffee grounds container is full.

Does anyone know the problem?

Does the flushing work? And hot water?

Greeting Stefan

--------------------
Esam 6600 PrimaDonna
Ich helfe gerne und freue mich über jede Rückmeldung, was leider nicht immer vorkommt. Fragen werden NUR im Forum beantwortet.

Mal bist du Hund, mal bist du Baum.

You mean, will the system check be run after the chatting? Yeah, it'll work. Hot water too.

I meant the switch-on flush.

Greeting Stefan

--------------------
Esam 6600 PrimaDonna
Ich helfe gerne und freue mich über jede Rückmeldung, was leider nicht immer vorkommt. Fragen werden NUR im Forum beantwortet.

Mal bist du Hund, mal bist du Baum.

So the flush on seems to be working: He drives up the brewing group and then lets hot water flow through. Something always drips out of the milk froth nozzle. That doesn't seem normal to me either. I had removed the brew group mechanism this morning because it was hopelessly dirty and all the coffee was poured next to it. In doing so I checked the smoothness of the thread and truly adjusted the position slightly. Is the brewing group controlled by the contact switch?

Greetings
Tom

The oringe of the milk foam nozzle is defective, so you have to contact the member looser.
The brewing group has a limit switch at the top and bottom. However, the lower one is mainly used for path measurement. From this point upwards the path is monitored by the reed board. I would change this one.

Greeting Stefan

--------------------
Esam 6600 PrimaDonna
Ich helfe gerne und freue mich über jede Rückmeldung, was leider nicht immer vorkommt. Fragen werden NUR im Forum beantwortet.

Mal bist du Hund, mal bist du Baum.