Miele CM 5100

I have a cm 5100 and have to change the drainage valve, I also want to clean the coffee spout < br> but I have not yet figured out how I can break it down, maybe someone in Forun has done something like this before and has a tip for me.< br>Greuss< br>Rudolf< br>

Hello,

the stainless steel plate of the outlet can be pushed down if you press the catch on the left
and right at the edge (you can see the gap at the
edge closely).
When the plate is gone, the further procedure opens up, because the
screws can be seen. The outlet distributor itself is also screwed down from below
times with a screw.

Gruß
BS

--------------------
Ich schaue hier nur noch ganz selten vorbei.
In verschiedenen anderen Foren bin ich mit
dem gleichen Nickname zu finden, falls mal
jemand Hilfe benötigt kann ich vielleicht dort
helfen.

THANK YOU

Hello everyone,
could one of you please explain in more detail how to remove the front panel labeled "Miele"? Unfortunately I had no success.

Thanks and greetings

Did not get the sheet metal off either. pull down is nonsense

Hello all.
Laterally at the plate are each a recess.
There I am with two small screwdrivers at the same time purely and could pull it down.
By coffee residues glued this and makes it difficult this then to solve.
The plate you get then completely down pulled down if you push the outlet again completely up.

Not comming off, strange.

well, i just sqeezed water+isopropyl alhohol, and water + fairy through nostrals and screw-hole (without needle) and with needle trough those noches at the sides and any gap i can find, it takes tami but cleaned it good .

...with syringe...