Jura e10 Error

This morning I want to turn on the machine no sound it look only the upper 2 outside and the lower 4 leds in the middle ? what does my machine have?

Hello Quake,

if the green LEDs flash then the system wants to be vented (see manual).

There are all the Leds red in the manual found nothing to bleed the system.I have no functions.

Red is fault 8, so blocked brewing unit. For this error there are corresponding repair sets with instructions in the net.

I replaced the red sealing ring on the brewing unit a month ago, it was the brewing unit jammed! You've also heard that the monitor tried to move the piston, but now nothing is happening to the machine and it immediately gets the fault?

Maybe there was a thunderstorm at your place?
Check if there are still 9V and 15V secondary at the transformer.

with us was no thunderstorm Measured 9.6 V and 17.4V.The boiler will not warm 0 Volt.

OK, THEN. In the black wire of the heater there is an overtemperature protection inside, in a transparent plastic grommet. Measure the wire to passage.

Passage is ok

So keep looking... The heater also has a temperature sensor. This should have a resistance of about 12 kOhm at room temperature.

The green LEDs are definitely not blinking?

Good day Hisholy, measured 9.9 kOhm, no green LED flashing.

Today it is quite warm, the resistance value is OK. If no voltage arrives at the heater, the green LEDs definitely do not flash, the transformer is OK, then only the power print remains...

The heater has roughly about 50 Ohm?

The heating has 37 Ohm. How much does such a power print cost?

35,88 + VAT, article number 64479. The question is only, how do you get it in Switzerland?

I have a coffee machine repair service nearby hoping I can get it there. How did you find out I was from Switzerland?